6pin Lay-Z-Spa Wifi Controller

Credit: I take no credit for the PCB design or contents; credits to the below, I have followed the guide and offer a self-soldered ready to configure 6-pin module: Visualapproach - https://github.com/visualapproach Information: The PCB comes soldered with the components ready for the 6-pin version of the Lay-Z-Spa pumps. I provide no guides on how to install or configure but this has been built and pre-flashed using the following guide: https://github.com/visualapproach/WiFi-remote-for-Bestway-Lay-Z-SPA The PCB should be placed in an electrical or project box to reduce the risk of contact with live components; this is NOT included but highly recommended. This does not work with the Lay-Z-Spa app itself, it gives you local control or control via a local system like Home Assistant or MQTT. You should pre-configure the device before connecting to the pump; power the device using the USB port, connect to the devices AP “Lay-Z-Spa module######” and configure offline via IP address or browser by using http://layzspa.local . Please read the manual for full setup instructions: https://github.com/visualapproach/WiFi-remote-for-Bestway-Lay-Z-SPA/blob/master/bwc-manual.pdf Disclaimer: This is a modification; if anything breaks or invalidates your warranty, I cannot accept liability as the seller. WARNING!

WARNING - Electric Shock Can Kill!!! Touching live electrical parts can cause fatal shocks or severe burns. Pull out the mains plug from the outlet before modifying any hardware.