Lay-Z-Spa Diy Wifi Controller - 6-Pin Version

I had to buy a minimum manufacturing quantity of the PCBs for the project below but I only needed one for the project. The PCB comes soldered with the components ready for the 6-pin version of the Lay-Z-Spa pumps. This has been built and pre-flashed with the version from the below. I provide no guides on how to install nor how to configure as this is in the guide below:https://github.com/visualapproach/WiFi-remote-for-Bestway-Lay-Z-SPA This is fully working on my Lay-Z-Spa AirJet Vegas 6 Person Hot Tub; it is also working via MQTT into Home Assistant. It is recommended that the PCB is placed in an electrical or project box to reduce the risk of contact with live components.

NoteYou should pre-configure the device before connecting to the pump; power the device using the USB port and configure offline. Please read the manual:https://github.com/visualapproach/WiFi-remote-for-Bestway-Lay-Z-SPA/blob/master/bwc-manual.pdf DisclaimerAs mentioned, this is a modification/hack. If anything breaks or invalidates your warranty, I cannot accept liability as the seller; it is your fault. WARNING! WARNING - Electric Shock Can Kill!!! Touching live electrical parts can cause fatal shocks or severe burns.

Pull out the mains plug before modifying any hardware. CreditI take no credit for the PCB design nor contents; credits to the below: Visualapproach - https://github.com/visualapproach ReflashingShould you need to reflash it due to a fault or corruption, you can use the below flashing tool:https://github.com/mossc001/LayZ-Flash