Softub Aqua-Flo Pump Heater Motor & Styropack Only Softtub No Control No Circuit

Softub Aqua-Flo Pump Heater Motor & StyroPack ONLY New Seal NO leaks. ****Control Panel & Circuit Board NOT Included**** ****Aqua-Flo Motor, Styrofoam & Cover ONLY**** ****Control Panel & Circuit Board NOT Included**** Copy & Paste link below to watch short video of motor running before it was put into the Styrofoam Hydropack. https://drive.google.com/file/d/1jvdFh8dLJxjwTvS4N155wo1GYeb1xJAq/view? Usp=sharing If the motor is running IT IS HEATING AS WELL but there is NO control of the jets, they will just run until you unplug the motor. If you have an air control assembly you can attach it to the 3rd smaller pvc pipe to increase the jet pressure. This has the interior insulation The unit will heat the water as the motors runs.

This can take up to 48 hours when you first fill the tub with cold water. (Keeping Lid Cover closed will heat faster) Be careful not to pull or yank the power cord too hard it was spliced together with connectors and electrical tape.(see last 2 pics) GFCI in working condition. The spa water is heated using a patented heat recovery system, which uses waste heat from the motor to heat the water.A heat exchanger coil wrapped around the motor transfers heat to the water in the coil while the pump circulates the heated water through the tub. Being sold in AS IS condition NO returns please. I have described this unit to the best of my knowledge.

The pump motor styrofoam is covered with a Hunter Green LeatherTex (a marine-grade vinyl). Will be shipped UPS Ground fully insured.If you're an hour or 2 away and want to pick it up send me a message.I can't control the shipping price. UPS charges by the box size and this is the lowest UPS Ground price. Thanks for stopping by!