Softub Circuit Board, Relays, Wiring, Housing, Power Cord & Gfc Plug, Analog

Get your Softub running today with this used circuitboard, plug it in and go.... Complete with housing, relays, wiring, power cord with GFCI, super clean, sparkles. This has been tested and performs correctly with the analog(black rectangle top controller). This circuitboard DOES NOT WORK with the "digital" display, sorry. Only works with the black top controllers with the temp dial that goes 1-10. NO RETURNS, please do not buy this and then tell me it does not fit your Softub, contact me first if you are not sure, no try outs allowed.

Water temp can be adjusted above 104 degrees, with adjustment on the board. Can be set, with your top controller, to get higher desired max temperature. FYI this was on Softubs until aprox. Early 2000's, not just yesterday. Returns are not accepted, please contact me with any questions about application you might have, there have been 5+ different circuitboards over the last 25 years.

This one was used on many models, double check part # 11205 please! Be certain your circuitboard is the problem please, hotwire the motor to see if it runs. Check voltage to the board, should be 110 volts. Next, un-plug the top controller from the circuitboard and the motor will run(with a good board). If the motor does not run, check for power to the relays, 110V into the first relay and out to the second relay.

When there is run signal(for heat or jets) the second relay engages and sends power to the motor. You can see which relay is which, follow wires, power in and power to the motor. Relays are often the first problem, tap the side of them to see if they are stuck off or even stuck on sometimes.... Picture is of exact part that will be shipped, cords and all. Contact me with questions please, 20+ years of Softub repair and service experience, thanks, Dale