Set Includes: Pump
Softub Digital Pump AquaFlo Motor Pack Heater Hydro Pack Softtub Soft Hot Tub Spa New Impeller New Seal NO leaks. Copy and paste the video link below to watch the short video of the motor running: https://drive.google.com/file/d/17iyfOxmByMmCBnDm_qC-d68o-hy4LkiD/view? Usp=sharing Unfortunately the control panel works intermittently. I was able to use the light function then a few days later the light would NOT work. A few days later the light began working again.
Some days you can set the control panel temp from 80-104 (as seen in the video link) then a few days later the temp gets stuck at 100 degrees. The push buttons are probably worn? The thermostat was NOT tested so I do NOT know if the temp shuts down at a desired temperature (when the control panel is working)The red "heat" light on the control panel DOES light up and the unit will heat the water as the motors runs. This can take up to 48 hours when you first fill the tub with cold water.If you turn it on and the control panel is stuck at 100, it will maintain the default setting of 100 degrees. If the motor is running IT IS HEATING AS WELL.
The spa water is heated using a patented heat recovery system, which uses waste heat from the motor to heat the water.A heat exchanger coil wrapped around the motor transfers heat to the water in the coil while the pump circulates the heated water through the tub. I am selling this unit for parts/repair AS IS because if you want a fully functioning unit with a fully working control panel, you will have to purchase a new control panel since this one is working intermittently. (Or replace it with your own working control panel from your old motor pack)Or purchase a brand new Hydro pack for $1800 The jets can be turned on manually by using the round knob. When it's on the left position the jets are not fully pushing water through the jets but twisting the knob to the right fully opens the jets (see pics) Being sold in AS IS condition NO returns please.IF YOU PURCHASE THIS THEN CHANGE YOUR MIND YOU PAY RETURN SHIPPINGI have described this unit to the best of my knowledge.Interior has been photographed and all serial numbers recorded. The pump motor styrofoam is covered with LeatherTex, a marine-grade vinyl.
The foam insulation inside the motor pack was brittle and disintegrating so it was removed. You can wrap foam around the pvc piping to retain the heat.*Small tear in pump cover (see last pic) Will be shipped UPS Ground fully insured.If you're an hour or 2 away and want to pick it up send me a message Thanks for stopping by!
Questions
Add new question to the seller