Softub Digital Pump Motor Pack Heater Hydro Pack Softtub Soft Hot Tub Spa

Softub Digital Pump AquaFlo Motor Pack Heater Hydro Pack Softtub Soft Hot Tub Spa New Impeller New Seal New GFCI NO leaks.New impeller Seal repair cost was $420 see last pic The control panel is stuck at 100 as of now and light is NOT working. It will maintain the default setting of 100 degrees. If the motor is running IT IS HEATING AS WELL. Other days the control panel goes from 80 - 104 and the light turns on. (Intermittent circuit board problem) but is still 100% FULLY FUNCTIONAL and will heat to 100 degrees if control panel is stuck at 100.

If you want the temp set to 90 (with a digital thermostat floating in tub) you will have to shut it down manually by pulling the plug. The unit will heat the water as the motors runs. This can take up to 48 hours when you first fill the tub with cold water. (keeping Lid Cover closed will heat faster) The spa water is heated using a patented heat recovery system, which uses waste heat from the motor to heat the water.A heat exchanger coil wrapped around the motor transfers heat to the water in the coil while the pump circulates the heated water through the tub. This was a 2 week rental until client's pump pack was repaired.

When I picked it up the light was working and the control panel went from 80 to 104. The temp heated to 100 +/- (There is a small difference with a digital floating therm) I am selling this unit for parts/repair AS IS because if you want a fully functioning unit , the circuit board will need to be repaired ($185 repair)(Or replace it with your own working circuit board from your old motor pack if you have one)Or purchase a brand new Hydro pack for $1800 + The jets can be turned on manually by using the round knob. When it's on the left position the jets are not fully pushing water through the jets but twisting the knob to the right fully opens the jets (see pic) The original cover was beige but I swapped it to green. Being sold in AS IS condition NO returns please. I have described this unit to the best of my knowledge.Interior has been photographed and all serial numbers recorded.

The pump motor styrofoam is covered with LeatherTex, a marine-grade vinyl. The foam insulation inside the motor pack was brittle and disintegrating so it was removed. You can wrap foam around the pvc piping to retain the heat.*Small paint drip on rear pump cover (see pic 4) Will be shipped UPS Ground fully insured.If you're an hour or 2 away and want to pick it up send me a message.I can't control the shipping price. UPS charges by the box size and this is the lowest UPS Ground price. Thanks for stopping by!