Spa Heater Element Center Terminals Flo-Thru Hot Tub Heating Coil 4kw 230/115v, new middle terminal Flo-Thru heater element, Incoloy 800 sheath, Stainless bulkhead fittings, large sealing o-rings, bulkheads are epoxy sealed on the backside too. Rated 240 volts 4.0kw AND 120 volts 1.0kw Certified, guaranteed good resistance and thorough ground fault tested, prior to shipping. Can be run on 230v as 4.0kw (4000 watts) or on 115v 1.0kw (1000 watts), fits many flo-thru heaters requiring middle terminals, Correct Tech, CTI, Ingenious, ACC SmarTouch Jr., and others. Includes an installation guide with tips on proper heating element use. Sized for 2.25" diameter flo-thru heater housings with 1-1/4" terminal spacing, with 1/2" bulkhead holes in housing, these are all very common, standard dimensions.
Overall length of this element is approximately 9-5/8". Not for housings smaller than 2.25" outside diameter, not for terminal spacing other than 1-1/4", not for hole size other than 1/2" terminal holes in housing, and not for replacing elements with offset terminals, please note. If you have a need for some other style or size, message us with those details please. For a proper fit you need your heater housing to conform to the details listed which again are: Stainless Steel Housing outside diameter must be 2.25" (2-1/4 inch) Housing hole size for terminals must be 1/2 inch. Housing hole spacing must be 1-1/4 inch center to center.
Housing must require an element with terminals near the center. Housing must require an overall element length of approximately 9-5/8 inch. (Longer lasting than elements rated 5.5kw which run extremely hot.) Ships out within 1 business day after receipt of payment, and tracking will be uploaded to classifieds board for you. Thanks for looking! Questions, message us please, we are here to help :)
Add new question to the seller